![]() ![]() ![]() Once the project has been loaded, in the status bar at the bottom left of VS Code, MyApp.sln is selected by default. Visual Studio Code will ask to restore the NuGet packages. MyAppįor this command to work you need to previously have configured Visual Studio Code to be launched from the terminal. Open the project using Visual Studio Code. In such operating system, you'll need to remove android ios maccatalyst from the platforms list. Mobile targets cannot be built under Linux. Then inside the same terminal, type the following to create a new project: dotnet new unoapp -o MyApp -preset=blank -platforms android ios maccatalyst wasm gtk -vscode In a terminal, type the following command: dotnet new install Uno.Templates Let's start by updating the Uno project templates. Developing an Uno Platform project Create the project You can find additional information about uno-check here. Follow the instructions indicated by the tool.If the above command fails, use the following: Run the tool from the command prompt with the following command:.To update the tool, if you already have an existing one: Install the tool by running the following command from the command prompt:ī. If the above command fails, use the following: ~/.dotnet/tools/uno-checkįollow the instructions indicated by the tool Run the tool from the command prompt with the following command: uno-check To update the tool, if you already have an existing one: dotnet tool update -g uno.check Install the tool by running the following command from the command prompt: dotnet tool install -g uno.checkī. ![]() When using a Visual Studio Preview version, you will need to run uno-check -pre.Ī.
0 Comments
Leave a Reply. |